Maketoys Battle Sentinel Gento Mod

Got tired of stripping down the top side of the feet to gain more degrees at the bend when posing the figure so I decided to mod their latest mold, Gento. I don't have the patience or will to stop and take a pic with each step I took so I'll give a brief explanation.

2X
Cut off the ankle ball joint and sanded down the surface where it was. There I glued a plastic strip. I cut a small alligator clip strip and drilled a hole in the ball and on the glued strip. I made sure the metal strip would fit tight and I superglued the strip to both ends (strip on bottom of leg and ball). Painted the plastic strip on bottom of leg matte black. Added 3 Kotobukiya Plaunit Duct Nozzles on the sides to add a little more length and add aesthetic to the bottom of the leg. Finally I cut a small strip of electrical tape and covered the skinny metal strip connecting the ball joint to the bottom of the leg.

Not a perfect job because I didn't have a slim blade to cut the ball joint perfectly. It left a flat surface on top of the ball joint so when bending all the way the ball joint doesn't have as sturdy of a grip as I'd like. Still, now I can pull off the sort poses I've always wanted too. :-D It also looks good in trailer mode. Not going to show that though. Too much work. :-P